Black Rib Cap with 3/4" NPT ports and Pressure Relief buttons
Rib Cap for with 3/4" female NPT ports.
OEM Replacement cap for LWH Series filtration systems:
- LWHSD
- LWHGAC
- LWH-D
- Cap: Polypropylene
- Maximum Temperature: 125F (51.7?C)
- Maximum Pressure: 75 PSI (5.17 bar)
WARNING: READ THESE INSTRUCTIONS BEFORE CHANGING OR INSTALLING. FOLLOW THESE INSTRUCTIONS TO REDUCE RISK OF DAMAGE.
CAUTION: Filter housing must be protected against freezing and extreme temperatures. Filter housings should not be in direct contact with sunlight for a prolonged period of time since UV rays can make housings brittle. Pressure should always be measured before installation and a water pressure regulator should be installed in the mainline or in front of the housing. Installers should make sure replacement filters are the correct length and are not too long so as to not cause stress on the housing. A leak detector must be installed on all installations where high pressure, water hammer and pressure spikes are known or suspected to be present and on all installations where pressure is over 60 psi. Failure to the above may result in cracking of the filter housing, water leakage, and water damage.
CAUTION: All filtration systems contain other parts that have a limited service life. Exhaustion of the service life of those parts often cannot be easily detected. Commonly, it is only after leakage has been observed or water damage has occurred that one is made aware that the service life has been exhausted.
IMPORTANT NOTICE: To prevent costly repairs or possible water damage we strongly recommend that the bowl or sump of all plastic housings be replaced periodically: every 5 years for clear sumps, and every 4 years for opaque sumps. If your sump has been in use for more than the recommended period, it should be replaced immediately. Be sure to date any new or replacement sump for future reference and indicate the next recommended replacement date.
